Why do I need to activate my safety showers and eye/face washes weekly?
10 September 2019
Hughes Safety Showers says that weekly activation of your emergency safety showers and eye/face wash units is paramount to ensure that all emergency equipment is operating properly. This process is stated as a requirement in European and International standards (EN15154 and ANSI/ISEA Z358.1-2014)
Not only will performing this test give you peace of mind that your emergency equipment is in full working order, but it will also ensure you remain compliant. If a shower fails to function correctly or further injures an employee you could face significant fines and/or imprisonment.
What is the purpose of a weekly activation test?
The weekly activation ensures that flushing fluid is readily available to the head(s) of the unit for the required time in the event of an emergency. This includes eyewash or eye/face wash heads as well as shower heads. It also clears the line of any sediment build-up that could prevent water from being delivered to the shower or eye/face wash and minimises contamination due to stagnant water in the pipework.
How long should the activation be?
The length of time needed for this test depends on how much water is contained in the unit itself and within the pipes that do not form part of a continuous circulation system. The aim of the test is to completely flush out any stagnant water in this pipework.
Whilst a quicker activation may seem sufficient, 5 minutes is recommended to ensure the pipework is fully flushed and any issues can be identified. In places where it is difficult to flush a large amount of water, the shower or eye/face wash should be activated for at least 1-2 minutes.
This testing should replicate a real-life scenario so you can be confident your safety shower and eye/face wash will perform correctly in the event of an emergency.
Take a look at our weekly activation page for more information and to watch our video
For more information, visit www.hughes-safety.com/weekly-activation