
![]() |
Mark Sennett
Managing Editor |
![]() |
Kelly Rose
Editor |
Home> | Plant & Machinery | >Barrier Systems | >Buildings material manufacturer fined for failings |
Home> | Plant & Machinery | >Hand Arm Vibration | >Buildings material manufacturer fined for failings |
Home> | Plant & Machinery | >Safety Light Curtains | >Buildings material manufacturer fined for failings |
Buildings material manufacturer fined for failings
28 July 2021
A BUILDINGS material manufacturer has been sentenced after a worker was diagnosed with Hand Arm Vibration Syndrome (HAVS) after repeatedly using vibrating tools above the recommended limits; and a second worker sustained electrical burns in a separate incident.
Peterborough Magistrates’ Court heard that the employee was diagnosed with HAVS after a HSE investigation established that he had been using percussive tooling at the company to clean down a machine used for forming cement sheets using a jet pressure washer, pneumatic chisels and a Kango hammer where he was regularly exposed to vibration above the recommended limit.
While a health assessment in 2012 had identified the symptoms of HAVS, recommending the employee was referred to a physician for detailed medical examination, this did not happen until 2016 when the employee was diagnosed with late stage 2 HAVS. This is a serious irreversible health condition, causing the fingers to become blanched and numb, preventing the employee from working with vibratory equipment.
In an unrelated case on 1 September 2017, a second employee sustained electrical burns to his left arm and side of face. The employee was with a second electrician installing a temporary cable repair to switchgear which was around 60 years old. Whilst the employees were trained electricians, neither had the competence to work on the switchgear and they were not provided with any circuit diagrams, drawings or an instruction manual. Neither were there any job specific risk assessments or safe systems of work in place. The two employees isolated all the switches on the right-hand bank of the panel, which was supplying electricity to production machinery, and assumed that this would render the back of that bank of switches as safe. However, while working on the last cable connection, the tool used by one employee met a live bus bar terminating support strip. This caused a flash, which resulted in electrical burns.
Etex (Exteriors) UK Ltd of Lichfield Road, Burton-on-Trent pleaded guilty to breaching Regulations 6(4), 7(1) of the Control of Vibration at Work Regulations 2005; Regulation 4 (3) of Electricity At Work Regulations Act 1989; and Regulation 5 of Management of Health and Safety at Work Regulations 1999. The company was fined £282,100 and ordered to pay costs of £12,294.
Speaking after the hearing, HSE inspector Roxanne Barker said, “With regards to the case of Hand Arm Vibration Syndrome this company failed to implement and maintain a system that would suitably monitor the recorded results of vibration data and trigger times, therefore failing to have effective controls in place to limit the duration and magnitude of exposure to vibration. They also failed to ensure that their employee was under suitable health surveillance to identify problems at any early stage to prevent serious ill health.
“Etex (Exteriors) UK Ltd also failed in its duty to ensure that those undertaking electrical work were suitably competent and given the right information to complete tasks safely.”
- Commit to protecting workers’ mental wellbeing
- Foundry fined after workers exposed to lead dust
- BSIF member survey
- Company fined after failing to identify asbestos
- Updates to EN 149
- Boss spared jail after teenager injured
- Experienced employee partially severs two fingers
- RoSPA launches groundbreaking ‘Falls Charity Appeal’
- Health and Safety Matters Podcast - Episode 27
- 21 million pieces of PPE shipped from China