Saxon Lifts Limited, Goods get ATEX lift

hsmsearch.com


	What next? Request further Information visit web site Send to friend Saxon Lifts Limited company's profile

Goods get ATEX lift
June 1st 2005

Saxon Lifts has installed a new design of surface mounted hydraulic goods lift, that meets ATEX requirements, for Rohm and Haas in Dewsbury.

The lift does not require a pit, reducing the cost and time needed for installation. It has a modular design and is freestanding.

Direct acting telescopic lift cylinders fitted to an integral lift mast, raise and lower the lift between levels.

At Rohm and Haas, the lift was installed in a hazardous area and had to comply with ATEX requirements, namely Zone 2, Gas Group 11B, Temperature T3 Category 3.

Hydraulic powerpack and controls are located 20m from the lift in a nonhazardous area.

For this installation, the lift was designed to carry 2000kg between levels that are 4.3m apart, at 100mm/sec, with the mast suspended internal lift car travelling within a fully clad lift shaft.

More articles from Saxon Lifts Limited:

Scissor lifts offer cylinder solution (1st June 2006)

There's a good chance that the beverage delivery system in your local pub uses gases made by Airliquide, and giving that process extra fizz are scissor lifts made by Saxon Lifts.

From Handling storing

PREVENTING STRAINS WHEN LIFTING DRAINS (1st August 2005)

Four heavy duty scissor lifts from Saxon assist with the loading and unloading of kiln cars carrying clay and plastic drainage products at Hepworth Drainage Products in Derbyshire.

From Handling storing